Good quality 12v Alkaline Battery - DG Sunmo 1.5V LR6 AM3 Alkaline AA Battery – Sunmol

TECH SPECS

1.Scope

1.1Reference Standards

GB/T8897.1 (IEC60086-1,MOD)（Primary Battery Part 1:General）

GB/T8897.2 (IEC60086-2,MOD)（Primary Battery Part2:Size and Technical requirements）

GB8897.5 (IEC 60086-5,IDT)（Primary Battery Part5：Safety of batteries with aqueous electrolyte）

1.2Environmental Protection Standard

The battery meets the standard of EU battery directives 2006/66/EC.

2.Chemical system, Voltage and Designation

Chemical system：Zn-MnO2(KOH),without Hg & Cr

Nominal Voltage: 1.5V

Designation : IEC：LR6     ANSI: AA     JIS:AM-3     Others:24A,E91

Operating Temp Range Spec of -20℃ to +60℃

3.Battery Size

Battery meets the picture standard

3.1 Inspection Tool

Using vernier calipers which precision is up 0.02mm. to avoid short-circuit, should paste on one insulation material on one end of the vernier calipers.

3.2 Acceptance Method

Using GB2828.1-2003 sampling program, special sampling S-3, acceptance quality limitation: AQL=1.0

Weight And Discharging Capacity

Battery weight about:22.0g

Discharging capacity:2200mAh(Loading43Ω，4h/day,20±2℃ RH60±15%,End-point   Voltage0.9V)

5. Open circuit voltage, loading voltage and short-circuit current

6. Discharging Ability

Accordance of shortest discharging time

1. Testing 9 batteries of each discharging way;

2. The result of the average discharging time from each discharging standard shall be equal to or more than the average minimum time requirement; no more than one battery has a service output less than 80% of the specified requirement;

3. The result of the average discharging time from each discharging standard shall be equal to or more than the average minimum time requirement, if one battery has a service output less than 80% of the specified requirement then take another 9 pieces to test again. This lot of batteries are qualified if     the result meets the NO.2 provision. If not qualified then will not test again.

7. Anti-leakage ability

8. Safety Requirements

Signs

The following signs are on the battery body:

1. Model: LR6/AA

2. Manufacturer and brand: Sunmol ®

3. Battery Poles: “+”and“-”

4. Expiry date or manufacturing date

5. Warnings.

Cautions For Using

1. This battery can’t be charged, leakage and explosion may happen when charging.

2. Make sure the battery is in correct position as + and -.

3. Short-circuit, heating, disposing of into fire or disassembling of battery is prohibited.

4. Battery can not be forced discharged, which leads to excess gassing and may result in bulging, leakage and de-crimping of cap.

5. New batteries and used ones can not be used at the same time. It is recommended to use the same brand when replacing batteries.

6. The battery should be taken out from the device which will not be used for a long time.

7. Exhausted battery should be taken out from the device.

8. Welding batteries are prohibited or it will cause damage.

9. The batteries should be kept from children, if swallowed, contact a doctor immediately.

11. Normal Package

Each 2,3 or 4 batteries in a shrink package,60 pieces in one inner box,12 boxes in one carton.

12. Storage and Expiry 

1. Batteries should be put in cool, dry and with air-flowing places

2. The batteries should not be exposed in sunshine or in raining places.

3. Do not mix the batteries which without labels

4. Storing in 20℃±2℃, 60%±15%RH condition. The storage time is 3 years.

13. Nominal discharging curve

Discharging condition: 20℃±2℃，RH60±15%